Toyota 4RunnerRail™ Bases + Trackballs
The 4RunnerRail™ by 67 Designs is also available as pre-configured 'Packs' with choice of holders.
Important Installation Warning
The 4RunnerRail™ by 67 Designs will require you to uninstall, work on and then reinstall a considerable part of your 4Runner center dash assembly. You will be required to use small hand tools at a workbench. Do NOT order the 4RunnerRail™ unless you are capable and fully prepared to undertake the work. You should allow 30-45 minutes to install and you will be required to drill 2 holes through your dash! Details of the installation process will be available to customers.
- The most adaptable Toyota 4Runner (5th Gen) dash mounting setup.
- The lowest profile Toyota 4RunnerRail™ Multi-Device mounting system on the market.
- A rail that sits discretely atop the dash for mounting up to 5 different nano length arms and devices. (Sold separately)
- Lowest profile for maximum forward visibility.
- Allows you to add Series 55 BT55 20mm ball mounting points, nano length arms and device holders.
- Using the Dam Adapter™, 1" ball type holders can be attached.
- Add no more than 1.2 lbs of total weight of holders and devices/cases.
- The 67 Designs base is 100% Designed and Made in the USA.
- Patent pending.
- Base is made of aluminum and hard anodized.
- Series 55 4RunnerRail™
- Base hardware for the Series 55 rail.
- BT55 20mm dia. trackball (number based on your selection above).
- 1 x 4mm L-wrench
- 1 x Packet of fasteners to install the base in the OEM dash.
- (Arms and holders sold separately.)
- It is not always possible to use this product or other mounting system depending on Federal, State and Municipality laws. Some States have strict rules on mounting devices that may, depending on poor positioning, impair a driver's ability to see the road.
- It is the responsibility of every customer - and not 67 Designs - to know the laws in their local area or in other regions if venturing from home.
- Research and know before purchasing any mount from 67 Designs.
- Do not install any devices and related hardware in a way to could interfere with the SRS airbag systems in your specific vehicle.
- Add no more than 1.25 lbs of total weight of holders and devices/cases.
- 67 Designs is not responsible for any improper or illegal use of the hardware.