Skip to content
If you need help configuring a system please send us a message via the 'Need a hand?' button lower right or call 469-646-8810. (M-F 9-4:30)
If you need help configuring a system please send us a message via the 'Need a hand?' button lower right or call 469-646-8810. (M-F 9-4:30)

Arm Clamps for 67 Designs Arms

$ 9.00
SKU ARM CLAMP PACK - 1 x 20mm [A44044]

Installation is Easy.

  • Undo the included fasteners and attach to a 67 Designs' carbon fiber arm (not included) and any existing hardware that has a 1 inch ball.

  • Installs in seconds. 

Benefits

  • Mix and match holders and devices. Reuse prior investment in other vendor's bases and device holders that may have a 20mm or 25.4mm (1") diameter ball.

  • Add an clamp set to the end of a 67 Designs' arm "core" and you can then attach a complete arm to a holder or base from another manufacturer.

  • Cast metal for years of service.

Available Packs

The options to connect a 67 Designs carbon fiber series "core" to 20mm and 25.4mm (1") ball hardware are as follows:

  • 1 x 20mm clamp set
  • 2 x 20mm clamp sets
  • 1 x 20mm clamp set and 1 x 25.4mm (1") set
  • 1 x 25.4mm (1") clamp sets
  • 2 x 25.4mm (1") clamp sets

CAUTION: Not designed to work with any other manufacturer arms. Only works with 67 Designs "cores". Using with non-67 Designs arms voids the warranty.


Important Generation 1 "G1" and Generation 2 "G2" information.

  • The Dam Adapter™ G2 castings ("non-ribbed")will fit the Carbon Fiber Arms G1 segments.

  • The Dam Adapter™ G1 castings ("ribbed") will NOT fit all Carbon Fiber Arms G2 segments.

  • If you purchased a 67 Designs pre-configured Pack or individual Carbon Fiber Arms after March 13th, 2021 almost certainly you will have been shipped the Carbon Fiber Arms G2.

  • If you have any doubts about which version to purchase, please contact Customer Service before ordering.

  • If you are looking to order the G1 'ribbed' version of the Dam Adapter, please contact Customer Service.

 

      • Bases, carbon fiber arms, holders and devices shown in the images on this page are for reference only and must be purchased separately.