on all orders over $90
on all orders over $90
As the name suggests, the components and packs in this lineup are focused on helping you build or extend your 67 Designs setup without needing an intermediate arm.
It should be noted that the AMPS, Diamond Plate and X-Plate with clamps can be both a Base and/or a mount to connect to a device with the hole pattern.
Get creative! Did you know you could connect an AMPS Plate with 20mm ball (C11744) + an AMPS Plate with 20mm Clamps (P75011) and create a simple 'knuckled' way to mount a device that has holes spaced for the AMPS holder? Mix-n-match to your hearts content.
If you have questions, contact Customer Service and we’ll be happy to assist.
The MagMount G3™ - No Arms Required™ No Arm Required™ is a very simple way to mount a MagMount G3™ on a surface without the need for an intermedia...
View full detailsInstallation is Easy. Open the clamps for either to 20mm or 25.4mm (1") ball by undoing the thumb nut. Install and re-tighten thumb nut. Ben...
View full detailsInstallation is Easy. Open the clamps for either to 20mm or 25.4mm (1") ball by undoing the thumb nut. Install and re-tighten thumb nut. Ben...
View full detailsInstallation is Easy. Open the clamps for either to 20mm or 25.4mm (1") ball by undoing the thumb nut. Install and re-tighten thumb nut. Ben...
View full detailsOverview 67 Designs offers this lightweight carbon fiber holder to attach your iPad housed in a Pivot Case. This carbon fiber adapter comes wi...
View full detailsBenefits Save space between the 1" bar and the driver. Save money not needing to buy an intermediate arm between the 1" bar and the device holder...
View full details